LD Systems LDMIX102AG3 Série Manuel D'utilisation page 7

19
MID
Mid-frequency equalizer (2.5 kHz) for the sum channel. Turn anti-clockwise to reduce and clockwise to increase mid-frequencies. The
equalizer is inactive in the centre detent position.
20
LOW
Low-frequency equalizer (80 Hz) for the sum channel. Turn anti-clockwise to reduce and clockwise to increase bass frequencies.
The equalizer is inactive in the centre detent position.
21
MAIN LEVEL
Volume control for the sum channel (master volume). Turn anti-clockwise to reduce and clockwise to increase volume.
22
BAL
Balance control for the sum channel. If the LD MIX102G3 passive speaker is used as a stereo extension, the balance slider adjusts the
volume balance between the left and right summed signals (left = Internal speaker, right = external speaker).
23
STEREO/MONO
If the LD MIX102G3 passive speaker is used as a stereo extension, select the STEREO switch position. If the sum channel is receiving a
stereo signal, the speaker system can now be used as a fully-fledged stereo PA system. If an external speaker is not being used as a stereo
extension, select the MONO switch position. In this case, any stereo signal will be summed into mono.
24
SPEAKER OUT
speakON-compatible speaker output for connecting the LD MIX102G3 passive speaker (minimum impedance 4 Ohms).
25
POWER LED
The power LED lights up when the device is properly connected to the mains and switched on.
26
MAIN LEVEL METER
2 x 4-segment level meter for the sum channel. If the red LED lights up, the device is being operated at its peak level. Momentary illumination
due to level peaks is not critical, however permanent illumination should be avoided by reducing the volume.
27
MONITOR OUT
Balanced line-out via 3-pin XLR jack. Connection option for an active speaker. The signal corresponds to the sum signal and is routed before
the volume control of the sum channel (MAIN level) so it can be set independently.
28
MONITOR LEVEL
Volume control for the monitor channel. Turn anti-clockwise to reduce and clockwise to increase volume.
29
SUB OUT
Balanced line-out via 3-pin XLR jack. Connection option for an active subwoofer. The signal corresponds to the sum signal and is routed
after the volume control of the sum channel (MAIN level) so it is dependent upon the main volume level.
30
SUB LEVEL
Volume control for the subwoofer output. Turn anti-clockwise to reduce and clockwise to increase volume.
31
FOOTSWITCH
6.3 mm jack socket to connect a footswitch (normal open contact, not supplied). Pressing the foot switch will mute the internal effects (DFX
MUTE). The PEAK LED will light up continuously. Pressing it again unmutes the effects and the PEAK LED will go out.
7