Troubleshooting - ETI GROW ELITE GL-250-MV Guide D'utilisation Et D'entretien

troubleshooting

Before doing any work on the fixture, disconnect power to the light fixture.
warninG:
Minor problems often can be fixed without the help of an electrician.
Problem
The fixture will not light.
The fuse blows or the circuit breaker
trips when the light is turned on.
The timer does not turn the grow light on
and off.
Possible Cause
The power is off.
The circuit breaker is off.
There is a defective switch.
The power cord is loose.
If using the GrowElite Remote Control,
TM
the grow light is not connected to the
remote control.
The power cord is grounding out.
If using the timer on the GrowElite
Grow Light, the fixture needs to be
reset.
If using the GrowElite Remote Control,
TM
the Grow Light settings are not correct.
Questions, problems, missing parts?
Call ETiSSL Customer Service
8 a.m. - 5 p.m., CST, Monday - Friday
1-855-ETI-SSLI (1-855-384-7754)
www.ETiSSL.com
Retain this manual for future use.
Solution
Ensure the power supply is on.
Ensure the circuit breaker is in the on position.
Contact a qualified electrician.
Remove the power cord from the outlet. Ensure
the power cord is firmly inserted into the
GrowElite light fixture and then plug the other
TM
end of the power cord back into the outlet.
Review the troubleshooting section of the
GrowElite Remote Control Instruction Manual -
TM
model number 90600366.
Contact a qualified electrician or call customer
service 1-855-384-7754.
Turn the GrowElite
TM TM
Spectrum Switch is on Flower or Veg and then turn
the light back on. Turn timer dial to 2 hrs to test if
the light stays on for the 120 minutes.
Contact ETi Solid State Lighting customer service
at 1-855-384-7754 for further assistance.
Make sure the Spectrum Switch is set to Remote
Control.
Review the troubleshooting section of the
GrowElite Remote Control Instruction Manual -
TM
model number 90600366.
light fixture off. Make sure the