Connecting The Power Cord - ETI GROW ELITE GL-250-MV Guide D'utilisation Et D'entretien

installation (continued)
7

Connecting the power cord

nOte: Make sure the distance between the electrical outlet and the end
of the light fixture is less than 10 ft.
□ Plug the power cord (B) into the end of the grow light (A) and then plug
the other end of the power cord (B) into an electrical outlet.
□ Attach the power cord (B) to the mounting cable (BB) with cable ties
(not included).
□ Secure the power cord (B) to the ceiling using cord clips (not included),
if applicable.
□ Use the power switch to activate the fixture.
CaUtiOn: When suspension mounting, make sure the
light fixture is located directly below the electrical outlet.
The power cord (B) should be secured to the mounting
cable (BB) with cable ties (not included).
nOtiCe: Once installed, the electrical cord should be visible over its entire 10 ft. length and:
□ Should not be concealed or extended through a wall, floor, ceiling, or other parts of the building structure.
□ Should not be located above a suspended ceiling or dropped ceiling.
□ Should not be permanently affixed to the building structure.
□ Should not be subject to strain or possible physical damage.
8
Choosing the light spectrum
This LED grow light allows you to choose the preferred
light spectrum.
□ Flip the spectrum switch to select either the
Flowering light spectrum or the Vegetating light
spectrum.
nOte: This fixture can be connected to
GrowElite remote control model # 90600366.
□ Set the spectrum switch to Remote Control if
using the Remote Control (sold separately) for
full spectrum control.
Power switch
Power
switch
Remote
control
Flower
Veg
Spectrum Switch
6
BB
A
B
Cable Tie