Table Des Matières; Safety Information; Warranty - ETI GROW ELITE GL-250-MV Guide D'utilisation Et D'entretien

table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Planning Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Tools/Hardware Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

safety information

warninG: Carefully read and understand the information
given in this manual before beginning the assembly and
installation. Failure to do so so could lead to electric shock,
fire, or other injuries which could be hazardous or even fatal.
warninG: Ensure the electricity to the wires you are
working on is shut off. Either remove the fuse or turn off the
circuit breaker
.
warninG: This product must be installed in accordance
with the applicable installation codes by a person familiar with
the construction and operation of the product and the hazards
involved.
warninG: Risk of electrical shock. To reduce the possibility
of serious injury, always take the proper precautions and
unplug the fixture before moving or cleaning.
CaUtiOn: To prevent eye damage, avoid looking directly at
the unshielded LEDs.
CaUtiOn: Ensure the fuse or circuit breaker provides
sufficient amperage for the 105°C rated power cord.
nOtiCe: Suitable for operation in ambient temperatures not exceeding
45°C/113°F. The temperature of the environment should be controlled
via a mechanical ventilation system, cooling system, or other means
to ensure the temperature within the growing space remains below
45°C/113°F when the Grow Light is in operation.

warranty

This product is warranted for a period of 5 years from the date of original purchase against defects in materials and workmanship. If this
product should fail to operate due to defects in material or workmanship within 60 months of purchase, see www.ETiSSL.com for details.
This product will be repaired or replaced, at ETi's option. This warranty is expressly limited to repair or replacement of product and liability
for direct, incidental, or consequential damages is hereby expressly excluded. Some states do not allow exclusions of direct, incidental or
consequential damages, so the above limitation of exclusion may not apply to you. This warranty gives the consumer specific legal rights,
which vary from state to state. WARRANTY IS VOID IF PRODUCT IS NOT USED FOR THE PURPOSE WHICH THIS PRODUCT IS MANUFACTURED.
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Hardware Included . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Additional Parts Available to Purchase . . . . . . . . . . . . . . . . . 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
nOtiCe: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and the receiver.
□ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
warninG: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
2