Master Forge 0182316 Mode D'emploi page 13

9. Thread the two side-
bolts of the chimney (M)
through the two holes
located on the side of
the lid (N). Use a pair of
flange nuts (FF) to
secure the chimney (M).
HARDWARE USED___________
M6
Flange
Nut
10. Remove the nut from the
temperature gauge (O),
attach the gauge to the
front of the lid (N),
replace nut and tighten.
Using 2 screws (CC),
attach the handle (P)
and insulation washer
(JJ) and handle base (T)
to the lid (N) via the two
holes below the
nameplate.
HARDWARE USED___________
M6 x 12
Screw
Insulation
Washer
9
x 2
10
x 2
x 2
13