Machine Cleaning - BEAL NPBR065/61 Notice D'emploi

gb
HAZARD - Blade sharpening and balan-
cing adjustment, including removal and
refitting, are demanding operations which
require specific competence, as well as
special equipment; especially for safety
reasons, these operations must be carri-
ed out by a specialised after-sale centre.
The same applies to blade replacement
with a new one.
HAZARD – Any damaged or bent blades
must always be changed for safety rea-
sons. Always use original blades.
44
INSTRUCTION MANUAL

5.2 MACHINE CLEANING

MACHINE
# Do not use high-pressure nozzles or aggressive
liquids to wash the casing and the engine.
ENGINE
# Periodically clean the air filter (fig.48-49) and
check the ignition plug electrodes (fig. 50-52).
To service the engine, follow the instructions in the
attached engine manufacturer's manual.
# At the start of each season, check the machi-
ne and have it serviced by a specialised after-
sales centre.
GRASS BAG
# The grass bag can be cleaned by means of a
strong jet of water.
BLADE DECK
# Washing the inside of the blade deck and of the
grass unloading pipe can be done as follows:
1) position the machine on an outside floor;
2) fit the grass bag;
3) connect the flexible water hose (fig.53 part 1) at
junction (fig.53 part.2) to the blade deck;
4) sit in the seat and engage the parking brake;
move the gear lever to neutral (N);
5) move the blade deck to minimum level (full
down);
6) start the engine;
7) allow the blade to turn for a few minutes.
Release the bag and rinse it with a strong jet of
water.