Max HN65 Manuel D'utilisation Et D'entretien page 14

Arm Cover
Contact Arm
WHEN USING THE TOOL FOR STEEL PLATES
●
●
●
●
●
This tool is exclusively designed for 1/16" (1.6 mm) to 1/8" (3.2 mm) thick light gage steel.
When using it, comply with the Work Standards, considering the object condition and work site environment.
q Select appropriate nails according to the object thickness,
seeing the right table.
※ The nails may not be driven into the object depending on its
hardness or thickness.
※ If the object is thinner than an appropriate range of thickness,
the nails may not be driven into it because of being bent.
Wood
Object thickness
(Total) range
Penetration
amount
Light gage steel:
1/16" (1.6 mm) to
1/8" (3.2 mm) thick
※ For the 1/8" (3.2 mm) thick light gage steel,
use the .113" (φ2.9 mm) nails.
CONTACT TIP
WARNING:
ALWAYS disconnect air supply before attaching / detaching the contact tip.
Attach the Contact Tip on the tip of Contact Arm, when driving nails to a soft material.
The Contact Tip can be kept on the Arm Cover when not using.
Contact Tip
WARNING:
Carry out work based on the required Work Standards.
If there is no specified work standard, refer the following as a reference.
Never use the nails for the ceilings (ceiling foundations included) or roofs (roof foundations
included).
Be sure to apply discharge outlet to an object at a right angle.
Do not drive the nails into the steel plate directly.
w If the thickness of the light gage steel foundations material used is 1/8" (3.2 mm),
use the .113" (
e Never drive the nails directly into the light gage steel because they will fly off,
endangering you.
r Be sure to apply the discharge outlet to the object at a right angle. If applied
obliquely, the nails will fly off, endangering you.
t Never use the nails for the roofs (roof foundations included) or ceilings (ceiling
foundations included).
y If the nails are driven into the steel plate too deeply, their holding force will be
extremely reduced. When working with the tool, fully check the driven conditions.
Nail Selection Criteria
Diamete Length
.099" 1-3/4"
(2.5mm) (45mm)
.099" 2"
(2.5mm) (50mm)
.099" 2-1/4"
(2.5mm) (57mm)
.099" 2-3/8"
(2.5mm) (60mm)
φ 2.9 mm) nails.
14
Object thickness Light gage
(Total) range steel thickness
1" to 1-3/8" 16 Gage to 13 Gage
(25 to 35mm) (1.6 to 2.3mm)
1" to 1-1/2" 16 Gage to 13 Gage
(25 to 40mm) (1.6 to 2.3mm)
1-3/8" to 1-3/4" 16 Gage to 13 Gage
(35 to 45mm) (1.6 to 2.3mm)
1-1/2" to 1-1/8" 16 Gage to 13 Gage
(40 to 55mm) (1.6 to 2.3mm)