Fein FSC1.6X Mode D'emploi page 18

OBJ_BUCH-0000000139-001.book Page 18 Friday, September 20, 2013 8:05 AM
en
18
Cutter blades for automobile glazing
applications (FSC1.6X, FSC1.6Q)
(figure 8).
Guide the straight, bent or offset cutter
blades at a right angle to the window flange;
blade A – D.
For U-shaped cutter blades, pay attention that
the traverse of the cutter blade is led parallel
to the window pane of the vehicle; blade C.
Fig. 8
The scraper knife is used for cutting back
bond remainders on the window flange or the
pane. Before re-bonding the vehicle window,
cut back the remaining bead to a height of
approx. 2 mm; blade E – F.
Cutter blades marked with a symbol may only
be operated as indicated.
Symbol on the cutting blade