Transporting And Mounting The Product - SMA GRID-CONNECT-BOX 12 Instructions D'emploi

SMA Solar Technology AG
5.3

Transporting and Mounting the Product

Danger to life if raised or suspended loads tip over, fall or sway
Vibrations or careless or hasty lifting and transportation may cause the product to tip over or fall. This can result in
death or serious injury.
• Always transport the product as close to the floor as possible.
• All means of transport and auxiliary equipment used must be designed for the weight of the product. Weight:
109 kg.
• Always transport and lift the product upright.
• Always maintain a sufficient safety distance from the product during transport.
• Take into account the center of gravity of the product. The center of gravity is approximately in the center of the
cabinet.
• Wear suitable personal protective equipment for all work on the product.
Damage to the product due to sand, dust and moisture ingress after setting down on
unsuitable surface
Setting the product down on an unsecured or uneven surface may cause the product to warp and allow sand, dust
and moisture to enter the product. Sand, dust and moisture penetration can damage the product and impair its
functionality.
• Never set the product down on an unsecured or uneven surface.
Overview of transport options:
The product is delivered on a Euro pallet. You can use the following means of transport to lift the product off the Euro
pallet:
• Forklift
• Crane with suitable fork
Additionally required mounting material (not included in the scope of delivery):
☐ 4 suitable screws to attach the product to the support surface
Procedure:
1. Remove all fastening screws from the kick plates at the front and rear (TX 30).
2. Remove kick plates.
3. Retain the kick plates and the fastening screws for later use.
4. Slide a suitable means of transport under the product.
5. Transport the product to the mounting location using a suitable transport lock.
Operating manual
WARNING
NOTICE
GRID-BOX-12-3-20-BE-xx-12
5 Mounting
15