Thermador PROFESSIONAL PRO HARMONY Serie Instructions D'installation page 22

To Reinstall the Oven Door
To Check Door Fit and Operation
1. Open and close the door slowly to test the movement
and the fit of the door to the oven cavity. Do not force
the door to open or close. If the door is properly
installed, it should move smoothly and rest straight on
the front of the range when closed.
2. The range must be level for proper alignment of the
oven doors, see "STEP 9: Placing and Leveling the
Range".
3. If the door does not operate correctly, verify that the
hinges are properly seated into the hinge slots, and
that the hinge clips are fully engaged into the slots.
Installation Instructions
1. Hold the door firmly in both
hands.
2. Hold the door at a 30° angle
from the closed position.
Insert hinges centered
evenly into the hinge slots.
The hinges will securely
hook into the slots when
properly installed. DO NOT
force, bend or twist the door.
3. Open door fully to expose
hinges, levers, and slots.
4. Flip the hinge forward and
down until seated on the
bracket. A screwdriver may
be required to carefully push
the clip back.
5. Close and open the door
slowly to ensure it is
correctly and securely in
place.
Figure 20: Door Install
4. If door or handle appears slightly tilted, you may adjust
the hinge receiver by rotating the large Torx-head
screw located directly below the hinge receiver with a
T-20 Torx driver. Rotate each screw respective to its
side and direction the door needs to be adjusted
(Figure 21).
Figure 21: Hinge Receiver Adjustment Screw
English 21