Regulating Minimum Output; Substituting The Nozzle In The Main Burner; Substituting The Nozzle In The Pilot Burner; Checking Functioning - Lotus CW-74G Instructions Pour L'installation Et L'emploi

After having carried out the conversion for another type of gas, it is necessary to regulate minimum output by turning
the screw to the right or to the left until the minimum heat output reaches 2.5 kW.

SUBSTITUTING THE NOZZLE IN THE MAIN BURNER

• Remove the front fixing screws from the panel, remove the start-up cable from the piezoelectric ignition device
• Using a suitable spanner, unscrew the nozzle and substitute it with the right one (see the technical data table).

SUBSTITUTING THE NOZZLE IN THE PILOT BURNER

The flame of the pilot burner has fixed air.
The only operation necessary is the substitution of the nozzle according to the type of gas.
It is therefore necessary to unscrew the screws as specified in the previous point; with a suitable spanner unscrew the
fitting and substitute the nozzle with a suitable one. With the right nozzle, the flame must lap the thermocouple.
Important!
After having carried out the conversion to another type of gas, it is necessary to update the data plate, indicating the
type of gas for which the appliance has been converted.
• The appliance contains the instructions necessary for use.
• Check the appliances for gas leaks.
• Examine the flame of the pilot burner; it must lap the thermocouple and be blue, otherwise examine the nozzle of
the pilot burner.
• Check the lighting and flame of the main burner.
• We urge the user to follow the instructions when using the appliance.
With prolonged use of the appliance, it is essential to carry out regular maintenance for the safe functioning of the
appliance; we therefore recommend drawing up a contract for after sales service.
Maintenance must be done only by specialized personnel, observing the norms in force and our indications.
It is possible to substitute parts such as: gas cock, piezoelectric device or gas piping in a very simple way. To substitute
the parts, proceed as follows:
• Cock: after taking off the front panel, unscrew the screwed fittings from the gas connections and the thermocouple
fitting, after which, substitute the cock.
• To substitute the thermocouple, unscrew the fitting of the pilot burner, likewise unscrew the thermocouple fitting
and substitute the element.
• The spark plug must be unscrewed and substituted.
Attention! In the event that smoke is given off when the appliance is started up, it is necessary to leave the appliance on
without being used for approximately an hour or until the smell disappears.
GB
IT

REGULATING MINIMUM OUTPUT

CHECKING FUNCTIONING

MAINTENANCE

Spare parts

INSTRUCTIONS FOR USE

27
IE
CH