Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installing Your Refrigerator
How to Install the Handles
Stainless Steel Models
1
Loosen lower door clip on
refrigerator door with
hex nut driver.
2
Locate predrilled hole at
base of handle, and fit
hollow end of handle
over lower door clip.
3
Fit other end of handle over
upper door clip and slide
up as far as possible.
NOTE: If top of handle does not fit over top
clip, loosen lower clip further until fit can be
accomplished.
How to Connect the Water Supply
Materials Needed
1
4
NOTE: Add 8' (2 m) to tubing length needed to reach water
supply for creation of service loop.
1
Remove plastic cap (A) from
water valve inlet port (B).
continued
/
"
1
4
!
WARNING
!
CAUTION
3
16
A
B
4
Insert
/
" hex nut driver
1
4
into predrilled hole at base
of handle and tighten screw.
5
Insert screw plug into
predrilled hole, as
illustrated.
6
Repeat steps 2 through 5 to
install freezer handle.
To remove after initial install...
IMPORTANT: To avoid damage to unit, use
a flat blade screwdriver edge wrapped in
masking tape to remove screw plugs.
2
Place brass nut and sleeve on copper tube
end and insert tube into valve inlet port.
6
1
4
Publicité
Table des Matières
