Technical Characteristics - IPC SG-45 Manuel D'instructions

Cleaning the filters.
Check the condition of the output filters on the water and deter-
gent tanks and steam generator regularly. Clean and remove
all dirt. Replace if excessively dirty.
The limescale filter in the boiler fill circuit must be changed
periodically.
Boiler maintenance.
On average, boiler maintenance should be carried out after
every 50 hours of operation. If the appliance is used with
especially hard water (> 15°TH), carry out maintenance more
frequently.
The boiler's scaling should be made only by an authorized
assistence service.
This operation requires the machine to be located in the assi-
stence service.
For maintenance and/or repairs, use only original spare
parts which offer the greatest characteristics of quality and
reliability. Failure to use original spare parts absolves the
manufacturer from all liability and transfers it to the person
carrying out the operation.
STORAGE
If the appliance is not used for long periods, unplug it from the
mains socket, clean the boiler. Protect parts which might be
damaged by dust. Empty the water and cleaning solution tanks
via the relative drainage bungs. Rinse the cleaning product
delivery circuit using clean water (fig. 10).
When used again, check there are no cracks or cuts in the
vacuum and solution/steam emission tubes and attachments.
SCRAPPING
If you decide to stop using the steam generator, you should
render it inoperative by removing the electric power cable. Parts
which might constitute a danger, especially to children playing
with the appliance, should be made harmless.
The steam generator is classified as special waste. It must be
taken apart and divided into uniform sections which should be
disposed off according to current legislation.
Do not use the components removed as spare parts.

TECHNICAL CHARACTERISTICS

Boiler volume l
Oper. pressure bar
Steam temp. °C
Abs. power. boil. W
Max. all. impedance Ohm
Solut. tank l
Water tank l
Del. pump W
Weight Kg
Noise level Lp dB (A) 70
Lw dB (A) 85
English
3,1
5,0
160
2850
0,35
2
7
60+60
20
TROUBLESHOOTING
Problem
The appliance does not work.
Cause
No voltage.
Faulty cable or mains switch.
Remedy
Make sure there is voltage.
Contact the service centre.
Problem
No chemical product delivered
Cause
Solution tank empty. (Intermittent beep)
Attachments dirty or clogged.
Detergent intake circuit clogged.
Pump does not suck.
Damaged delivery pump.
Remedy
Fill the solution tank with cleaning product.
Clean attachments.
See paragraph on filling the cleaning product suction circuit.
Contact the service centre.
Problem
Water leaks from junction of attachments.
Cause
Junction seal worn or leaky.
Remedy
Check, clean and lubricate seals. Replace if necessary.
Problem
Attachments do not fit perfectly.
Cause
Dirt has accumulated in the junctions and rapid couplings.
Remedy
Clean and lubricate junctions and rapid couplings.
Problem
No steam is being delivered.
Cause
Boiler not yet up to pressure ("E" indicator light out).
No voltage.
When the water tank is empty, the light "D" comes on (continu-
ous beep emitted) when the steam switch is operated.
Steam switch not activated.
Remedy
Wait a couple of minutes until the "E" light on the panel goes out.
If the problem persists, contact the service centre.
Check there is voltage. Check the appliance is plugged in
correctly.
Add clean water to the water tank.
Make sure the switches are activated.
- 14 -