Handle Installation And Removal - IKEA P5WB12NL Instructions D'installation Et D'utilisation

Parts Included: Refrigerator door handles (2),
Freezer drawer handle (1)
Tools Needed: ¹⁄₈" Hex key wrench
Install Door Handles
NOTE: Handle mounting setscrews are preinstalled inside the
handle.
1. Remove the handles from the packaging inside the
refrigerator.
2. Open a refrigerator door. On the opposite door, place the
handle on the shoulder screws with the setscrews facing the
adjacent door.
A
A. Shoulder screws
B. Setscrews inside the handle
3. Firmly push the handle toward the door until the handle base
is flush against the door.
4. While holding the handle, insert the short end of the hex key
into the upper hole and slightly rotate the hex key until it is
engaged in the setscrew.
5. Using a clockwise motion tighten the setscrew just until it
begins to contact the shoulder screw. Do not fully tighten.
6. Repeat steps 4 and 5 to fasten the lower setscrew.
7. Once both setscrews have been partially tightened as
instructed in the previous steps, fully tighten both setscrews.
IMPORTANT: When the screws feel tight, tighten them an
additional quarter-turn. The handle is not properly installed
without this extra tightening.
8. Repeat steps 2 through 6 to install the other handle onto the
adjacent refrigerator door.

Handle Installation and Removal

1. With the freezer drawer closed, place the handle on the
B
2. Firmly push the handle toward the drawer until the handle
3. Insert the short end of the hex key into the left-hand hole and
4. Using a left to right motion tighten the setscrew a quarter-turn
5. Repeat steps 3 and 4 to fasten the right-hand setscrew to the
6. Once both setscrews have been partially tightened as
7. Save the hex key and all instructions.
1. While holding the handle, insert the short end of the hex key
2. Using a right to left motion loosen the setscrew a quarter-turn
3. Repeat steps 1 and 2 for the other setscrew. Slowly pull the
4. If necessary, use a Phillips screwdriver to remove the shoulder
Install Drawer Handle
shoulder screws with the setscrews facing down toward the
floor.
A. Shoulder screw
B. Setscrews inside the handle
base is flush against the drawer.
slightly rotate the hex key until it is engaged in the setscrew.
at a time. Repeat until the screw feels tight.
shoulder screw.
instructed in the previous steps, fully tighten both setscrews.
IMPORTANT: When the screws feel tight, tighten them an
additional quarter-turn. The handle is not properly installed
without this extra tightening.
Remove the Handles
into a setscrew hole and slightly rotate the hex key until it is
engaged in the setscrew.
at a time.
handle away from the door or drawer.
screws from the door.
A
B
9