Endress+Hauser FTS 20 Mode D'emploi page 18

Installation
The floating switch can be installed as follows:
• The floating switch can be inserted into the tank – through a tapped hole G1A – and screwed to
the compression gland (G1A).
• If it is installed from above, use the weight.


Note!
• The fulcrum of the cable should always be horizontal.
• The cable length between the fixture and the floating body is dependent on the cable type
(see "Technical data").
• When using the weight, place an extra strain relief (e.g. a knot in the cable) behind the com-
pression gland – on the outside of the tank.
E
..
6 Endress + Hauser