Assembly Of Throttle Wire And Ignition Wire - Dolmar MS-4211 Manuel D'instructions Original

ASSEMBLY OF THROTTLE WIRE AND IGNITION WIRE

– Remove the air cleaner cover.
– Place the control cable (1) in the adjusting bolt (2), and shift the swivel (3) so
that the cable will be put in the swivel groove. At this time, the round-hole
side of the swivel will be oriented toward the inner wire end-metal fitting.
– Release the swivel, and confirm that the inner wire-end metal fitting will be
placed in the hole.
– Mount the air cleaner cover.
Adjust the control cable by adjusting bolt so that it will have 1 to 2 mm play
when the throttle lever is set to the low-speed position by carburetor adjusting
bolt. (Be careful that the cutter blade will not turn in idling.)
– Connect the female and male bullet connectors (4) from throttle assembly to
the male and female bullet connectors coming from engine.
– Install the air cleaner cover.
10