Filling And Starting - FUXTEC FX-MSP2.2 Mode D'emploi

Original-Bedienungsanleitung FUXTEC FX-MSP2.2_de_en_fr_ita_rev09

Filling and starting

1.Testing before commissioning
1) Check if the spark plug etc. is loose.
2) Check if the air cooling opening is blocked to prevent overheating.
3) Check if the air filter is dirty.
4) Press the starter 2-3 times to see if the machine's operation is regular.
2. Refuelling
1) Switch off the engine before filling the tank.
2) We recommend a petrol mixture 25:1 - 40:1; the oil must be 2-stroke engine
oil. For the first 4-5 hours of operation, a mixing ratio of 25:1 should be used. An
incorrect mixing ratio can destroy the function of the motor. The unit is not
designed for special fuels or ready-mixes.
3. Filling of chemicals
1) While filling the chemicals, the OPEN / CLOSE switch must be locked, as shown
in Fig.8. While the spray tank is being filled with the chemical, the machine should
be placed on the floor. Otherwise, chemicals may escape from the device.
2) Because the chemical powder can easily block the spray lines, the chemical
should not be in the tank for long.
3) While spraying, the chemical tank cap should be tightly closed. After spraying
the chemical, please clean the lid of the chemical tank cap and tighten the cap.
31