Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.1
PROBLEM(S)
Pilot plasma is
not stable
during
operation.
Cut is at wrong
angle.
Cut is too wide,
cut quality is
poor.
Visit www.princessauto.com for more information
20A Plasma Cutter
POSSIBLE CAUSE(S)
1.
Compressed air is too low
or too high.
2.
Electrode of cutting torch
or nozzle is burnt.
3.
Connection between
ground cable and
workpiece is poor.
4.
Cutting speed is too slow.
1.
Nozzle or electrode is
burnt.
2.
The installation position of
nozzle and electrode do
not match.
3.
Cutting speed is too high.
4.
Nozzle axis is not plumb
with the plane.
1.
Cutting speed is too slow.
2.
Torch's electrode or nozzle
is burnt down.
3.
Cutting speed is too high.
4.
Wrong type of nozzle
used.
SUGGESTED SOLUTION(S)
1.
Adjust pressure.
2.
Replace electrode or nozzle.
3.
Connect firmly.
4.
Adjust speed.
1.
Replace nozzle or electrode.
2.
Correctly install both.
3.
Slow down cutting speed.
4.
Adjust the torch angle.
1.
Accelerate cutting speed.
2.
Replace electrode or nozzle.
3.
Slow cutting speed.
4.
Replace with a suitable
nozzle.
8901183
23
Publicité
Table des Matières
