Power Cord - Powerfist CUTPRO 20 Mode D'emploi

V1.1
POWER TOOL PRECAUTIONS
This equipment requires a dedicated 115 volt, 15/20 amp single-phase
alternating current circuit equipped with a similarly rated circuit breaker or
slow blow fuse. Do not run other appliances, lights, tools or equipment on the
circuit while operating this plasma cutter.
1. Do not use a power tool with a broken or inoperative trigger/power switch
or safety guard.
2. Make sure the power switch is in the OFF position before connecting the
tool to the power supply.
3. Do not drape or carry coiled welding cables on your body when the cables
are plugged into the plasma cutter.
4. Do not start the tool when the electrode is touching the workpiece.
5. Hold the tool by the insulated gripping surfaces when performing an
operation where it may contact hidden wiring or its own cord and cables.
Contact with a 'live' wire will electrify exposed metal parts and shock the
operator.
6. Take work breaks to prevent the tool's motor from overheating and/or
overloading. Refer to the plasma cutter's duty cycle in Specifications.
7. Keep hands away from the electrode and the area it is being applied to
when the tool is in operation.
8. Do not connect the plasma cutter ground clamp to an electrical conduit.
Do not weld on an electrical conduit.
9. When the tool is in operation, keep hands away from the area it is being
applied to.
10. Do not connect the cutting unit ground clamp to an electrical conduit. Do
not weld on an electrical conduit.
11. Do not touch the surface immediately after use. The surface will be hot
and may cause an injury.
12. Do not allow persons who are not familiar with the tool or have not read
these instructions to use the tool.

POWER CORD

1. Insert the power cord plug directly to the power supply whenever possible.
Extension cords are not recommended for use with this plasma cutter.
Visit www.princessauto.com for more information
20A Plasma Cutter 8901183
13