Care & Maintenance; Torch Maintenance - Powerfist CUTPRO 20 Mode D'emploi

8901183
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to
control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for changing accessories.
4. Only use accessories intended for use with this tool.
5. Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.

TORCH MAINTENANCE

WARNING! Unplug the cutting unit before replacing consumables to avoid an
injury from accidental activation of the plasma torch.
The electrode, nozzle and protective cup will require cleaning and replacement
over time. The electrode will slowly wear away as it is used to ignite the pilot
plasma. The nozzle will become contaminated with dross during the cutting
process. The protective cup can crack or be damaged. Disassemble the torch to
replace or clean the components.
1. Make sure the plasma cutter is shut down.
2. Disconnect the air supply.
3. Unscrew the protective cup (Fig. 3-4). Inspect and replace if the protective
outer material is cracked, damaged or burnt.
a. Waste material may accumulate on the protective cup and may cause
the arc to connect to the
side and prevent the pilot
plasma from igniting.
Clean the protective cup
of waste material.
4. Check the nozzle (Fig. 3-3) and
distributor (Fig. 3-2) and
replace if damaged or burnt.
5. Unscrew the electrode (Fig. 3-1). Check for damage or if it is worn down to
less than 2 mm. In either case replace the electrode.
20
20A Plasma Cutter
For technical questions call 1-800-665-8685
V1.1
Fig. 3