Assembly & Installation - Powerfist CUTPRO 20 Mode D'emploi

8901183
IDENTIFICATION KEY
A Power LED
B Cutting LED
C Overload LED
D Amperage Dial
E Torch Socket (-)
ASSEMBLY & INSTALLATION
Letter references in parenthesis (A) refer to the included Identification Key.
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
1. Connect the work clamp lead to the earth socket (F) and tighten by hand.
2. The torch is directly connected to the torch socket (E) and does not
require installation.
INSTALL THE AIR SOURCE
The plasma cutter uses compressed air with the plasma arc to create an ionized
cutting arc. A compressor is the best choice to provide air, but a cylinder of
compressed air may be an option when a compressor is not available. The
cutter's working pressure range is 58 to 72 PSI.
16
20A Plasma Cutter
F
G
H
I
For technical questions call 1-800-665-8685
Earth Socket (+)
Power Switch
Power Supply Cord
Air Connection
V1.1