Atag HL311M Mode D'emploi page 30

operation
switching on
switching on
1 Put a pan on the cooking zone
2 Press the on/off button.
A horizontal line (-) appears in the display.
on/off switch 3 Press quick-selector button 12.
12 appears in the display.
4 Press the + button.
A1 appears in the display. If the button is pressed again,
quick-selector the next setting appears. You can choose from 9 settings
button 12 (see table).
As long as there is the letter A in the display – A3, for
example – a high power level is being used for fast
cooking.
If there is only a number – 3, for example – the cook-
+ button
through setting has been switched on.
In the table below, you can see the fast-cook times for the
various fast-cook settings. The number after the A indicates
fast-cook setting the setting used for cooking through. On fast-cook setting
A6, for example, the food is fast-cooked at a high power level
switched on
for the first ten minutes and then cooked through on
setting 6.
setting
A1
A2
A3
A4
A5
A6
A7
GB 8
fast-cook time setting searing time
1,5 minutes A8 2 minutes
2 minutes A9 2,5 minutes
3 minutes
4 minutes
6 minutes
10 minutes
13 minutes
timer
You can have the rear cooking zones switched off by the
timer.
1 Put a pan on one of the rear cooking zones.
2 Press the on/off button.
A horizontal line (-) appears in the display.
3 Set the power level required.
4 Set the timer.
The cooking time is set using the + and – buttons (max.
3.59 hours).
The number of minutes selected is shown in the display.
longer shorter
A blinking dot indicates that the timer has been activated.
At the end of the cooking time, you hear a beep.
The zone switches off.
Switch the beep off at the end of the cooking time by
pressing the clock's + or – button.
If you do not switch the beep off, it will stop automatically
after 20 minutes.
childproof lock
The appliance is fitted with a childproof lock. If the childproof
lock is switched on, the controls cannot be used.
childproof lock locking
Press the key symbol until the red light comes on.
unlocking
Press the key symbol (± three seconds) until the red light
goes out.
operation
switching on
GB 9