What Should I Do If; Extra Facilities; Beep - Atag HL311M Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

faults

what should I do if...

If the appliance does not work properly, this does not always mean that it is defective.
Try to deal with the problem yourself first. Phone the service department if the advice
given below does not help.
fault
cause
Cooking zones do not get
Plug is not in socket.
hot.
Fuse(s) in the meter
cupboard defective.
Error codes F00-F18 in the
A button is defective or
display.
dirty or there is an object
on top of it. Each button
has its own number, from
00 to 18. The number
associated with the button
appears in the display.
Error code F3 appears.
Appliance has overheated.
It is possible that too large
a pan has been placed on
the front-right zone.
Appliance does not work.
Appliance is locked.
GB 12
solution
Put the plug into the
socket.
Check the meter cupboard.
Clean the appliance or
have it repaired.
Do not place any objects
on the control panel.
Allow the appliance to cool
down until the code
disappears.
Press on the key symbol
for three seconds
continuously.
switching the beep off/on
The beep, which can be heard when the buttons are pressed,
can be switched off or on.
switching the beep off
1
Switch the front-left cooking zone on and then off by
pressing the on/off button twice.
on/off button front-
2
Immediately afterwards, press the – button belonging to
left cooking zone
the front-left cooking zone for five seconds.
A beep confirms the setting that has just been selected.
The beep for the front-left and rear-left cooking zones is now
switched off.
Repeat this operation for the right-hand cooking zones using
– button for front-left
the on/off button and the – button for the front-right cooking
cooking zone
zone.
switching the beep on
1
Switch the front-left cooking zone on and then off by
pressing the on/off button twice.
2
Immediately afterwards, press the – button belonging to
the front-left cooking zone for five seconds.
A beep confirms the setting that has just been selected.
The beep for the front-left and rear-left cooking zones is now
switched on.
Repeat this operation for the right-hand cooking zones using
the on/off button and the – button for the front-right cooking
zone.

extra facilities

beep

GB 13

Publicité

Table des Matières
loading

Table des Matières