Spektrum AR6410NBL Manuel D'utilisation page 9

2.4GHz Troubleshooting Guide
Problem
Aircraft will not
"throttle up"but
all other controls
seem to function
LED on aircraft
remains flashing
and cannot be
controlled by
transmitter
Controls appear
to be reversed
after binding
to a different
transmitter
Aircraft does not
function after
connecting flight
battery and
aircraft smells
burnt
Possible Cause
User did not lower
throttle trim and throttle
stick prior to initializing
the aircraft
Throttle channel
is reversed. Futaba
transmitters (equipped
with Spektrum
modules) may require
you to reverse the
throttle channel
User did not wait at
least 5 seconds after
powering the transmit-
ter prior to connecting
the flight battery to
the aircraft
User bound the aircraft
to a different trans-
mitter
Transmitter was too
close to aircraft during
the initialization process
User did not initially set
up transmitter prior to
binding to the aircraft
User may have
accidentally plugged
the flight battery in with
the wrong polarity
9
Solution
Lower throttle stick and
throttle trim to their lowest
settings
Reverse throttle channel
on specific transmitter if
applicable
Unplug, then reconnect
flight battery
Rebind aircraft to your
desired compatible
transmitter
Move transmitter (powered
on) a few feet from the
aircraft prior to reconnect-
ing the flight battery
See the "Advanced
Programming" section of
this manual
Replace AR6410NBL board
and ensure the RED polar-
ity marks are facing the
same direction when
connecting the flight bat-
tery to the AR6410NBL
board
EN