Yardworks 060-1330-4 Guide D'utilisation page 15

DRIVE CONTROL (IF EQUIPPED)
DRIVE CONTROL LEVER(S)
1. Self-propelling is
controlled by holding
the operator presence
control bar down to
the handle and pulling
the drive control
lever(s) rearward to
the handle.
The further toward the
handle the lever is
pulled, the faster the
machine will travel.
2. To stop forward motion without stopping the engine,
release the drive control lever(s) only. Hold the
operator presence control bar down against the
handle to continue mowing without self-propelling.
DRIVE CONTROL HANDLE
1. Self-propelling is controlled by holding the
operator presence control bar down to the handle
and pulling the drive control handle to the handle.
2. To stop forward motion without stopping the
engine, release the drive control handle. Hold the
operator presence control bar down against the
handle to continue mowing without self-propelling.
Drive Adjustment
Note: The drive system consists of pulleys, a belt,
and a cable linking the transmission to the drive
handle. As these components wear, adjustment may
be needed. To adjust the drive linkage perform the
following:
• Loosen the locking nut with a wrench (not
supplied).
• Hold the upper bolt and turn the stop nut clockwise
to shorten the cable, counter-clockwise to lengthen
the cable.
• Start the mower to test the function of the drive
control handle and tighten the locking nut once
self-propel can engage.
Note: The cable must be
loose with the self-propel
drive bar in the released
position; otherwise, the
machine may creep when
the drive control handle
is disengaged.
Note: Self-propelled
speed can change on
slopes
Upper bolt
Locking nut
Self-propel cable Stop nut
tension kit
NOTE: After releasing the drive control, if the mower
will not roll backwards, push the mower forward
slightly to disengage the drive wheels.
TO CONVERT MOWER
Your lawn mower may have been shipped ready to be
used as a mulcher. Convert to bagging or discharge
modes by changing the installed accessories.
NOTE: This lawn mower has three functions. Change
functions by changing the installed accessories as
shown in the following chart.
REAR BAGGING
1. Lift rear door of the
lawn mower.
2. Remove the mulching
plug when you set
your lawn mower for
rear bagging.
3. Place the grass
catcher frame hooks
onto the grass bag
brackets.
NOTE: For clarity, rear
door is not shown.
15
®
/MD
Mulching plug