Jdash1 : Tuning Controller Connector; Jbat1: Clear Cmos (Reset Bios) Jumper - MSI MPG X570S CARBON MAX WIFI Mode D'emploi

JDASH1 : Tuning Controller connector

This connector is used to connect an optional Tuning Controller module.

JBAT1: Clear CMOS (Reset BIOS) Jumper

There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumper to clear the CMOS memory.
Resetting BIOS to default values
1. Power off the computer and unplug the power cord
2. Use a jumper cap to short JBAT1 for about 5-10 seconds.
3. Remove the jumper cap from JBAT1.
4. Plug the power cord and power on the computer.
30
Overview of Components
1 No Pin
3 MCU_SMB_SCL_M
5 VCC5
Keep Data
(default)
2 6
5
1
2 NC
4 MCU_SMB_SDA_M
6 Ground
Clear CMOS/
Reset BIOS