Jbat1: Clear Cmos (Reset Bios) Jumper; Jdash1 : Tuning Controller Connector - MSI MPG Z690 EDGE WIFI DDR4 Manuel D'utilisation

JBAT1: Clear CMOS (Reset BIOS) Jumper

There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Resetting BIOS to default values
1. Power off the computer and unplug the power cord.
2. Use a jumper cap to short JBAT1 for about 5-10 seconds.
3. Remove the jumper cap from JBAT1.
4. Plug the power cord and Power on the computer.

JDASH1 : Tuning Controller connector

This connector is used to connect an optional Tuning Controller module.
30
Overview of Components
Keep Data
(default)
1 No Pin
3 MCU_SMB_SCL_M
5 VCC5
Clear CMOS/
Reset BIOS
2 6
1 5
2 NC
4 MCU_SMB_SDA_M
6 Ground