Emissions Information - DeWalt DXGNR 7000 Manuel D'instructions

Assembly
Disconnect negative (-) battery terminal FIRST (A).
1.
Disconnect positive (+) battery terminal SECOND (B).
2.
B
A
Install new battery. Install hold down bracket and tighten.
3.
Connect positive (+) battery terminal (B) FIRST (B). Slide
4.
rubber boot over connection hardware.
Connect negative (-) battery terminal (A) SECOND.
5.
Slide rubber boot over connection hardware.
6.

Emissions Information

The Environmental Protection Agency and California Air
Resource Board for generators certified to CA standards
requires that this generator comply with exhaust and
evaporative emission standards. Locate the emissions
compliance decal on the engine to determine what stan-
dards the generator meets, and to determine which war-
ranty applies. This generator is certified to operate on
gasoline. The emission control system includes the fol-
lowing components (if equipped):
•
Air Induction System
– Intake Pipe / Manifold
– Air Cleaner
•
Fuel System
– Carburetor
– Fuel Tank / Cap
– Fuel Lines
– Evaporative Vent Lines
– Carbon Canister
•
Ignition System
– Spark Plug
– Ignition Module
•
Exhaust System
– Exhaust Manifold
– Muffler
– Pulsed Air Valve
– Catalyst
6
000224
Owner's Manual for Portable Generator