Install Handle; Battery Replacement/Connection; Emissions Information - DeWalt DXGNR6500 Manuel D'instructions

Assembly
Install Frame Foot and Rubber Bumpers
Slide rubber foot (E) through frame foot (B). Install locking
1.
flange nuts (K).
Slide M8 bolt (J) through holes in frame rail. Slide frame foot
2.
(B) onto M8 bolts. Install locking flange nuts (K).

Install Handle

Slide M8 carriage bolt (H) through handle bracket and han-
1.
dle assembly (C) by first inserting the bolt through the
square hole in the handle assembly (C).
Install M8 flange nut (K).
2.

Battery Replacement/Connection

The battery shipped with the generator
NOTICE:
has been fully charged. A battery may
lose some charge when not in use for prolonged periods
of time. If battery is unable to crank engine, plug in the
12V charger included in the accessory box (see
Charging the Battery (electric start units only)
IMPORTANT: Running the generator does not charge
battery.
Accidental Start-up. Disconnect the
WARNING
negative battery cable, then the posi-
tive battery cable when working on unit. Failure to do so
could result in death or serious injury.
Disconnect negative (-) battery terminal FIRST (A).
1.
Disconnect positive (+) battery terminal SECOND (B).
2.
B
A
Install new battery. Install hold down bracket and tighten.
3.
Connect positive (+) battery terminal (B) FIRST (B). Slide
4.
rubber boot over connection hardware.
Connect negative (-) battery terminal (A) SECOND.
5.
Slide rubber boot over connection hardware.
6.
8

Emissions Information

The Environmental Protection Agency and California Air
Resource Board "for generators certified to CA stan-
dards" requires that this generator comply with exhaust
and evaporative emission standards. Locate the emis-
sions compliance decal on the engine to determine what
standards the generator meets. This generator is certified
to operate on gasoline. The emission control system
includes the following components (if equipped):
•
Air Induction System
– Intake Pipe / Manifold
– Air Cleaner
•
Fuel System
– Carburetor
– Fuel Tank / Cap
– Fuel Lines
– Evaporative Vent Lines
– Carbon Canister
•
Ignition System
– Spark Plug
– Ignition Module
•
Exhaust System
– Exhaust Manifold
– Muffler
– Pulsed Air Valve
– Catalyst
000224
Instruction Manual for Portable Generator