Panasonic AJ-EC3P Manuel D'utilisation page 9

Parts and their functions
B
PAINTING GAIN VRs
R GAIN and B GAIN controls
C
PAINTING ENABLE switch
This is used to enable the PAINTING GAIN and BLACK VR controls.
D
PAINTING BLACK VR
R PEDESTAL and B PEDESTAL controls
E
KNEE POINT VR
This is used to set the manual knee point.
F
KNEE SLOPE VR
This is used to set the manual knee slope.
G
AUTO IRIS switch
AUTO IRIS ON/OFF switch
H
IRIS VR
When the G AUTO IRIS switch is ON, this control adds the control value to, or subtracts it
from, the IRIS LEVEL on the user menu. This addition or subtraction is performed over a
range of -2 steps to +2 steps. When the same switch is OFF, it is used to adjust the iris finely.
I
GAMMA VR
This enables the camera's master gamma to be varied in 0.01 steps from 0.35 to 0.65.
J
DETAIL VR
This enables both H DETAIL and V DETAIL to be varied at the same time.
K
INDICATOR
This lights when a lens extender is used.
L
M.PED VR
This is used to set the master pedestal.
M
Number display LED
The iris value and the gain or filter positions are displayed on this LED. Normally, the iris
value is shown but when the gain value or filter position has been changed, the respective
value is displayed.
N
CHECK switch
The gain value, filter position and iris value are displayed in this order on the number display
LED by pressing this switch. The iris display is restored after a prescribed period of time has
elapsed.
O
FILTER INDICATOR
This lights when the filter position is shown on the number display LED.
P
GAIN INDICATOR
This lights when the gain value is shown on the number display LED.
E-8