emerio SEW-121820.1 Mode D'emploi page 7

THREADING THE SEWING MACHINE
1. Threading upper thread
Caution: Always switch off the appliance, disconnect the appliance from the power supply and remove the
foot pedal when threading the machine.
1) Turn the hand wheel to raise the needle to its highest position.
2) Put a spool on the thread spindle, put on the thread spindle cover and then pull out the thread.
3) Pull the thread and let it pass through the bobbin winder tension disk. (mark ① in the pic. below)
4) Guide the thread through the groove and pull it up towards the chromed take-up lever. (marks ② & ③ in
the pic. below)
5) Feed the thread through the hole in the chromed lever and pull it straight down towards the needle.
(marks ④ & ⑤ in the pic. below)
6) Feed the thread through the hole in the needle holder, then through the eye of the needle from the front
side to the back and pull out 10cm to the back. (mark ⑥ in the pic. below)
2. Replacing the bottom bobbin
1) Slide the bobbin cover button to the right and remove the bobbin cover (Fig.7).
Fig.3
Fig.5
- 6 -
Fig.4
Fig.6