emerio SEW-121820.1 Mode D'emploi page 14

Presser foot curling
Leather roller presser
Nail withhold presser
Note: Please choose the applicable presser foot based on the practical sewing of fabric.
Caution: Do not use other presser foot except above mentioned ones.
MORE TIPS
1. Make sure there is fabric under the needle when the machine is working and needle is moving, otherwise
the machine will get stuck and the thread will be jammed.
2. Turn the hand wheel for 2 to 3 circles by hand to test if it goes smoothly or not before starting the machine.
Direction to turn the hand wheel should be the same as the arrow's direction on the hand wheel.
3. Make sure the machine was threaded correctly (do not forget any step or have wrong threading).
4. Do not sew the cloth with too much elasticity, neither too thin (like silk) nor too thick cloth, please follow
the IM for the applicable cloth.
5. If the machine gets stuck or jammed due to wrong operation, turn off the power & speed switch
immediately.
6. Before winding the bobbin, please take out the bottom bobbin and the upper thread.
TROUBLE SHOOTING
Problem
No power or the machine
runs slowly.
Skip stitches.
Bobbin thread cannot be
drawn up.
Thread keeps breaking.
Problem cause
Batteries are installed incorrectly.
Batteries are low.
Adaptor power is inadequate.
Needle eye is not in the middle.
Needle is bent.
Presser foot is too loose
Lower thread has been used up.
Needle is threaded incorrectly.
Needle is bent.
Needle shank is not properly
seated.
- 13 -
Pattern 5 to 12 Used to make a 5mm
three-folded flat curling edge
of the fabric, with the center
of the straight stitch suture,
for
processing.
Pattern 1 to 12 Use the roller presser foot,
evenly
synthetic
very useful when sewing
cloth coat and leather into
cloth of difficulties.
Pattern 8 Use to nail two or four
buttons, it can suppress
buttons smoothly, to avoid
buttons
when sewing.
Solution
Reinstall the batteries in a correct way.
Use new batteries.
Use compatible adaptor.
Remove and re-insert the needle with
the flat side of the needle to the back.
Remove and re-insert a new needle.
Tighten the presser foot.
Replace it with a new full bobbin.
Re-thread the needle, making sure it is
threaded from the front to the back.
Remove and re-insert a new needle.
Remove and re-insert a new needle.
some fabric edging
into the leather,
leather, denim,
moving around