Leica Rugby 260SG Manuel De L'utilisateur page 43

Shut-off timer
Backlight
Remote reception
Rugby 260SG / 270SG / 280DG, Accessories
The remote is set from the factory to shut off after two minutes of not being used.
To change this shut-off time, enter the remote programming screen by pressing and
holding the STAR button, then pressing the POWER button.
When the Rugby select screen is shown, press and hold the STANDBY
button for 1.5 seconds. The shut-off time will change between 120, 60, or
30 seconds each time the button is held.
The LCD backlighting is normally turned off to conserve battery power.
To backlight the display on the remote, press the POWER button a second
time after the remote has been turned on.
The remote is an RF (radio frequency) device with an internal antenna. Always ensure
that the remote is within the "line of sight" of the Rugby.
If the remote loses communication, hold
the remote at a different angle to
improve reception.
41