Listening To Cds - auna 10032044 Mode D'emploi

EN
30
STORING AND RECALLING STORED STATIONS
In either DAB or FM mode, you can store up to 20 stations to the favourite
presets; this will enable you to get direct access to your favourite stations.
1. To store a preset, first tune to your desired station, then press and hold
the PRESET/CLOCK SET button, the display will show "Preset Store <01:
(Empty) >".
2. Press the TUNE- or TUNE+ button to select your desired station preset
number and then press the SELECT/ALBUM button to confirm your
selection, the display will show "Preset # stored".
3. To recall a preset station, first press the PRESET/CLOCK SET button
once, and when the display shows "Preset Recall", press the TUNE- or
TUNE+ button to scroll up or down the presets that you have stored,
when you see your desired preset number in the display, press the
SELECT/ALBUM button.

LISTENING TO CDS

To select the CD mode, repeatedly press on the STANDBY/FUNC button
until "CD" is displayed.
NOTE : Although this CD/MP3 player can read CD-R and CD-RW discs in
addition to normal CDs, the playability of CD-R and CD-RW discs may be
affected by the type of software that was used to create the discs, as well as
the quality and condition of the blank media you are using, 100% playability
cannot be guaranteed. This is not an indication of a problem with the player.
Playing the entire CD
1. When the unit is entered into the CD mode, the display will first show
flashing "Reading" and then finally "NO" to indicate that there is no disc
being loaded.
2. To load the disc, lifting up the CD door at the top, the display will show
"Open".
3. Load the disc with the printed label side facing up and then close the CD
door. The display will first show "Reading" and then start playback from
the first track. The display will show the track number and the play time.
4. To interrupt playback, press the PLAY/PAUSE button once, and the
playback will be paused.
5. To resume playback, press the PLAY/PAUSE button again.
6. To stop playback, press the STOP button, the display will show the total
number of tracks in the disc.
7. To select a different track during playback, press the TUNE- or TUNE+
button until you read your desired track number in the display, playback
will be started from this track.