auna 10032044 Mode D'emploi page 28

EN
28
Station order
1. To perform Prune, in DAB mode, press and hold the INFO/MENU button
to enter into the Menu, repeatedly press the TUNE- or TUNE+ button
followed by pressing the SELECT button to select "Station order".
2. Again press the TUNE- or TUNE+ button followed by pressing the
SELECT button to select "Ensemble " or " Alphanumeric"
DAB secondary services
On some occasions you will see a ">" symbol directly after the name of the
station, this indicates that there are secondary services available to that
station. These secondary services contain extra services that relate to the
primary station. E.g. a sports station may want to add extra commentaries.
The secondary services are inserted directly after the primary station. To
select the secondary station, press on the SELECT control once.
DAB automatically scan
This scan will search for the entire DAB Band III channels. After the scan
has finished, the first alphanumerically found station will be automatically
selected.
To activate automatically scan, press and hold the STOP/SCAN button, the
display will show "Scanning ..." and a progressing slide bar.
All the stations that have been found will be stored automatically, to
explore the stations that have been found, press the TUNE- or TUNE+
button and when you find a station that you would like to listen to, press the
SELECT button.
DAB display modes
In DAB mode, every time you press the INFO/MENU button, the display will
cycle through the following display modes:
DLS > Signal strength > Programme Type > Ensemble/Multiplex (Group
name) > Frequency > Signal error > Audio Bit Rate > Time > Date > DSL ...
DLS
DLS stands for Dynamic Label Segment which is a scrolling message that
the broadcaster may include in their transmissions. The message usually
includes information such as programme details ...etc.
Signal strength
The display will show a slide bar to indicate the signal strength, the stronger
the signal, the longer the bar will be from left to right.
Programme type
This describes the style of the programme that is being broadcast. If the
information is not available, the display will show "<Programme Type>".