Listening To The Radio - auna 10032044 Mode D'emploi

LISTENING TO THE RADIO

Hints for better reception
This radio is fitted with a single DAB/FM telescopic antenna, to obtain
the best performance, you should fully extend the antenna and adjust its
position as well as the direction until you find the best reception. For ideal
DAB reception, always maintain the antenna in an upright vertical position
is highly recommended.
DAB mode
If the radio is switched on for the first time, it will automatically enter into
the DAB mode and perform auto scan function. During the scan the display
will show "Scanning ..." together with a slide bar that indicates the progress
of the scan and the amount of stations that have been found so far. Once
the scan has finished, the radio will select the first alphanumerically found
station. You can now press the TUNE- or TUNE+ button to explore the found
stations.
To select DAB mode during other operation modes, repeatedly press the
STANDBY/FUNC button until the display shows "Welcome to DAB".
To enter into the DAB Menu, press and hold the INFO/MENU button, then
repeatedly press the TUNE- or TUNE+ button to step through the following
sub menus: Manual tune / Prune / Station order / System.
DAB manual tune
1. To activate manual tune, press and hold the INFO/MENU button to enter
into the Menu, repeatedly press the TUNE- or TUNE+ button followed by
pressing the SELECT button to select and confirm "Manual tune".
2. The display will show "5A" to "13F" and their associated frequencies,
press the TUNE- or TUNE+ button to move through the DAB channels,
when your desired frequency appears in the display, press the SELECT
button to confirm. The name of the station group (ensemble/multiplex)
will be displayed.
3. To listen to the station selected, press the SELECT button again.
Prune
You can remove the DAB stations in the station list that cannot be received
in your area. These are listed with a '?' prefix.
1. To perform Prune, in DAB mode, press and hold the INFO/MENU button
to enter into the Menu, repeatedly press the TUNE- or TUNE+ button
followed by pressing the SELECT button to select "Prune".
2. Again press the TUNE- or TUNE+ button followed by pressing the
SELECT button to select <Yes>.
EN
27