Manual Operation; Maintenance - Accorroni CHIP MONO DC INVERTER 2500W Mode D'emploi

displays and a selected temperature of ''8°C''.
(46°F if Fahrenheit is adopted). Repeat the operation to quit the function.

4.5. Manual operation

Manual operation can be used temporarily in case you cannot find the remote controller or its batteries are exhausted.
Panel

5. MAINTENANCE

Household
Drain
Cleaner
31
1. Open and lift the front panel up to an angle until it remains fixed with a
clicking sound.
2. One press of the manual control button will lead to the forced AUTO
Manual switch
operation.
3. Close the panel firmly to its original position.
CAUTION:
● Once you push the manual button, the operation mode will be selected
according to the room temperature as: COOL, HEAT, FAN.
● Press the button to stop the operation of the air conditioner.
WARNING
It is necessary to stop the air conditioner and disconnect the power supply before
cleaning.
No Cleaning the indoor unit and remote controller
CAUTIONS
● Use a dry cloth to wipe the indoor unit and remote controller.
● A cloth dampened with cold water may be used on the indoor unit if it is very dirty.
● The front panel of the indoor unit can be removed and cleaned with water. Then
wipe it with a dry cloth.
● Do not use a chemically treated cloth or duster to clean the unit.
● Do not use benzene, thinner, polishing powder, or similar solvents for cleaning.
These may cause the plastic surface to crack or deform.
Cleaning the air filter
A clogged air filter reduces the cooling efficiency of this unit. Please clean the filter
once every 2 weeks.
1. Lift the indoor unit panel up to an angle until it stops with a clicking sound.
2. Take hold of the handle of the air filter and lift it up slightly to take it out from the
filter holder, and then pull it downwards.
3. Remove the AIR FILTER from the indoor unit.
- Clean the AIR FILTER once two weeks.
- Clean the AIR FILTER with a vacuum cleaner or water, and then dry it up cool place.
4. Remove the healthy filter from its support frame as shown in the Figure on the left
(Not applicable to the units without electrostatic filter).
Do not touch this Electrostatic Filter within 10 minutes after opening the inlet grille; it
may cause an electric shock.
● Clean the electrostatic filter with mild detergent or water and dry in the sunlight for
two hours.
● Before re-install the Electrostatic Filter, check whether the corona line or support
frame is damaged or not.
5. Install the air freshening filter back into position.
6. Insert the upper portion of air filter back into the unit taking care that the left and
right edges line up correctly and place filter into position.