CAPITAL SPORTS OUTRUN 2XC Mode D'emploi page 44

EN
44
Oil Reminder Function (OIL)
Your treadmill needs lubrication maintenance when the running belt
resistance is too large. The system will display an"OIL"icon on your LED s time.
You can continue running by pressing any key"to eliminate the „OIL" prompt.
The system will continue to give the oil reminder until the running belt is
lubricated.
Note: The buzzer will beep 5 times simultaneously when the "OIL" shortage
prompt pops up.
No-load Protection Function
Once the treadmill has been inactive for one minute, it will pause
automatically. There are two situations at this time:
• If someone is operating on the treadmill, the machine changes from pause
state to running state and the motion parameters will be accumulated.
• If nobody is operating the treadmill, the treadmill will stop automatically
and all exercise parameters will be cleared to zero. Once the accumulative
time exceeds 10 minutes, the treadmill will enter into „SLEEP MODE" and
all digital tube lights on the screen will shut down. To reactivate, press any
key.
View the Information
• To view the total mileage, disconnect the emergency stop switch and press
SPEED+, SPEED- , SPEED+ buttons successively.
• To lit all LED lights, disconnect the emergency stop switch and press
START, PAUSE and START buttons successively.
• To view the version number, disconnect the emergency stop switch and
press START, SPEED+ and START buttons successively.