Battery Removal - Braun 3090cc Mode D'emploi

Keeping your shaver in top shape
Replacement light for shaving parts / Reset
• To maintain 100% shaving performance, replace the Foil & Cutter cassette (1), when
the replacement light for shaving parts (8) comes on after about 18 months or when
worn.
• The replacement light will remind you during the next 7 shaves to replace the Foil &
Cutter cassette. Then the shaver will automatically reset.
• After you have replaced the Foil & Cutter cassette (1), press the on/off switch (4) for
at least 5 seconds to reset the counter.
• While doing so, the replacement light blinks and goes off when the reset is complete.
The manual reset can be done at any time.
Preserving the batteries
In order to maintain the optimum capacity of the rechargeable batteries, the shaver has
to be fully discharged by shaving every 6 months approximately. Then recharge the
shaver to full capacity.

Battery removal

This appliance contains rechargeable batteries. Before disposing of the appliance,
disassemble the housing as shown, remove the rechargeable batteries and recycle or
dispose of properly, according to local guidelines.
Caution: Disassembling the appliance will destroy it and invalidate the warranty.
1. 2.
Clean&Charge Station (C)
The Clean&Charge Station has been developed for cleaning, charging, lubricating,
disinfecting, drying and storing your Braun shaver.
Important
• Only use the power supply special electric cord set supplied with the shaver.
• Do not place the appliance in a mirror cabinet, nor store it over radiators, nor place it
on polished or lacquered surfaces. Do not expose to direct sunlight.
• In order to avoid any leakage of the cleaning fluid, place the appliance on a flat, stable
surface. Do not tip, move suddenly or transport in any way if a cleaning cartridge is
installed.
10
3. 4. 5.
Ni - MH