Braun 3090cc Mode D'emploi page 11

• The appliance contains flammable liquid. Keep it away from sources of ignition.
No smoking.
• Do not refill cartridge. Use only original Braun refill cartridge.
DANGER: FLAMMABLE. CONTENTS MAY CATCH FIRE. Do not smoke. Use only in
well-ventilated areas. Keep away from flames such as pilot light, and any object that
sparks such as electric motor. Keep locked up. KEEP OUT OF REACH OF CHILDREN.
CAUTION: MAY IRRITATE EYES. Do not get in eyes.
FIRST AID TREATMENT: Contains ethanol. If swallowed, call a Poison Control Centre
or doctor immediately. Do not induce vomiting. If in eyes, rinse with water for
15 minutes.
Description
1 Start/release button
2 Contact bow
3 Lift button for cartridge exchange
4 Level indicator
5 Cleaning cartridge (not with all models)
Before using the Clean&Charge Station
Installing the cartridge
• Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into the base as far as it will go.
• Slowly close the housing by pushing it down until it locks.
Replacing the cartridge
• After having pressed the lift button to open the housing, wait for a few seconds before
removing the used cartridge.
• Before discarding the used cartridge, make sure to close the openings using the lid of
the new cartridge, since the used cartridge will contain contaminated cleaning
solution.
• The used cartridge can be disposed of in the household waste.
Operating your Clean&Charge Station
• Connect your Clean&Charge Station with the cord set to the mains electricity supply.
The special socket at the back is adjustable to save space. After each shave, switch
the shaver off and put it into the Clean&Charge Station, upside down and with the
front showing.
• Push the start/release button (1) to lock and connect the shaver. The cleaning
process will start. The yellow light on the shaver will flash during the complete
process (approx. 2 minutes cleaning, min. 4 hours drying).
• Do not interrupt the cleaning process, as it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press the start/release button (1).
11