FAULT
1
The fountain will not turn on, the
motor will not run and the tank
will not warm up
2
The fountain is turned on and the
tank heats up but the motor does
not spin even when the tank is
very hot.
NB: the motor starts only after the
tank is heated up
3
Chocolate drips
4
Chocolate does not run smoothly The appliance is not positioned on
5
Chocolate flows intermittently
6
The flow is intermittent
7
Chocolate does not become fluid Adjust the knob until reaching the
32
8.0 TROUBLESHOOTING
POSSIBLE CAUSE
Check the general fuse (F)
Likely motor block due to the
circuit breaker intervention.
Chocolate is not very fluid,
a flat surface.
The appliance is not positioned on
a flat surface.
Make sure there are no obstacles
to the smooth chocolate flow into
the pan and to the tower.
Even the air presence may cause
an irregular flow
desired consistency.
Check that the heater is turned
on:
the switch light bulb (H1) must be
on with the switch pressed to the
ON position
The light bulb is not turned on.
Note: The light bulb (H1) off does
not necessarily indicate that the
heater is not working, the bulb
itself may be faulty;
CHBG00EV - ENGLISH
REMEDY
Replace it if necessary.
Reset the circuit breaker.
(See point 8)
Dilute with vegetable oil.
Find a stable plane.
Find a stable base so that
chocolate is evenly distributed
around the tower base
Stop the auger, wait until the
chocolate flows out completely
into the pan and then restart it.
Possibly add chocolate if necessary.
Check the connection to the
electrical socket and that the fuse
is not interrupted, if necessary,
replace it with an identical original
model.
Check the heating through the
increasing temperature of the
tank, preferably without content
(chocolate).