Troubleshooting - mspa MONO C-MO049 Manuel D'utilisation

TROUBLESHOOTING

ERROR CODE CHART
LED READING
Water temperature is lower than 0°C
degree or exceeds 55°C (131°F)
E0
Temperature sensor failure
Water flow switch failure
Filter failure
E1
Water level is not at minimum water line
PROBLEM
NO DISPLAY ON
THE WIRED
CONTROLLER
NOT HEATING
PROPERLY
BUBBLE AIR
BLOWER DOES
NOT WORK
CAUSE
CAUSE
Power failure
PRCD is off
PRCD broken
Press the Reset button,
controller is not displayed
Temperature set too low
Dirty filter cartridge
Water level is not at the minimum
water line
Heater failure
Filter pump broken
Auto-off 10 minutes
Unidirectional threshold is not open
Control panel failure
Change the water or contact the MSpa
Service Center.
Contact the MSpa Service Center.
Add water above the minimum line.
Check power supply
Reset PRCD by following PRCD Testing
section
Contact the MSpa Service Center
Contact the MSpa Service Center
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact the MSpa Service Center
Contact the MSpa Service Center
Wait for 10 minutes
Contact the MSpa Service Center
Contact the MSpa Service Center
21
SOLUTION
SOLUTION