Cleaning And Storage - Waring Commercial WEK200 Mode D'emploi

Using the Adjustable Slicing Guide
The adjustable slicing guide is to be used as an optional tool to
ensure slices remain consistent and uniform. Use of the slicing guide
is not required to operate the knife and can be stored in the provided
storage/charging case until necessary.
Attaching/Adjusting the Slicing Guide
To attach the slicing guide to your knife, first ensure the Safety
Interlock is in the locked position.
Looking at the bottom of the unit,
attach the blade guide by inserting and
tightening the provided thumb screw
once you have selected the desired
thickness (markings are found on the
underside of guide, see fig. A).
To adjust the slicing guide, loosen
thumb screw and slide guide until the
desired marking is lined up with the
pin (see fig. B). Tighten thumb screw
to ensure the guide is securely in place
prior to use. During extended periods
of use, check every so often to make
sure thumb screw does not require
re-tightening.

CLEANING AND STORAGE

NOTE: Always engage lockout after each use or while it is not in use.
1. CAUTION: Engage safety switch to lock position before
handling blades. To remove the blades, push the blade release
button and grasp the blades with the cutting edge away from
you. Slowly pull blades out from knife housing.
2. To wash, remove slicing guide (place screw in secure place),
and separate the blades by sliding the rivet out of the keyhole.
Wash them in hot, soapy water or in the dishwasher and dry
thoroughly. Return to carrying/storage case.
3. Clean the handle with a slightly damp cloth and wipe dry.
Caution: Do not clean handle with blades in place. Do not immerse
the appliance in water or other liquid or place it under running water.
CHARGING
We recommend that you store your appliance in the carrying/storage
case when not in use, and be sure to plug knife into outlet while in
the case so it is fully charged and always ready for use.
Any other servicing should be performed by an authorized service
representative.
fig. A
fig. B
6
A