Busy Function - urmet domus BiBus II 1072 Manuel D'utilisation

STAIRCASE LIGHTS FUNCTION
Press the button programmed for this function. A
command will be sent to the special decoder and a
confi rmation beep will be heard.
NOTE: If the staircase lights button is pressed
during the programming procedure, it will
be reprogrammed with the user code
corresponding to the position.

BUSY FUNCTION

This function is only required in systems with more
than one calling device. This function is used to
ensure that a conversation lasts suffi ciently long
following a call. An intermittent beep will be heard
on the speaker for the time before the busy time-out
and the panel will be disabled.
Two cases can occur:
Busy time before the call user goes on-hook:
This is the maximum time for the user to lift the
handset or open the door without loosing the call
after the ring.
Busy time after user goes on-hook:
This is the minimum guaranteed conversation
time from when the handset is lifted.
TROUBLESHOOTING
Establishing the cause of problems related to a door
unit with digitiser Ref. 1072/5 is simple (e.g. no
courtesy tone after a call button is pressed):
• short-circuit on push-button panel side (L1,L2);
• neither bus couplers are programmed as masters.
MAINTENANCE AND REPLACEMENTS
Some devices in the system may need to be replaced
in time for maintenance purposes. This paragraph
indicates what needs to be reprogrammed.
Door unit with digitiser Ref. 1072/19A:
• Replacing door phone with digitiser Ref. 1072/18
with model Ref. 1072/19A.
Make the wiring without changing the sequence
of the buttons.
In video system with power unit 1772/6, video
power terminal GND must be connected to door
unit terminal R1 and not to door unit terminal
GND.
16
Program the following
programming adapter 1072/60 and keyboard
1032/65:
• System type: 1st edition
• Station number (ID): enter the value of the
replaced station
• Electrical lock energising time: enter the value
of the replaced station
The door phone DO NOT need to be programmed.
• Replacing door phone with digitiser Ref. 1072/19-
19A with model Ref. 1072/19A.
Make the wiring without changing the sequence
of the buttons.
Program the following
programming adapter 1072/60 and keyboard
1032/65:
• System type: 2nd edition
• Station number (ID): enter the value of the
replaced station
• Electrical lock energising time: enter the value
of the replaced station
• Hang-up waiting time and busy time: enter the
value of the replaced station
• Code type: enter the value of the replaced
station
• User codes: enter the value of the replaced
station
The door phones DO NOT need to be programmed.
Door unit with digitiser Ref. 1072/19A replacing
model Ref. 1072/18 in 1st edition BIBUS systems
INT
ID
NO
Sch. 1072/19A
NC
C
Sett/Fab
~12
EXT
II ED.
~0
SN
EXP
R
R1
L1
L2
GND
SP
PA
Ref. 1072/19A
N.B.: The buttons associated to the expansion
modules will not send the call if the wire is not
inserted correctly.
parameters
parameters
C
1
2
Sch. 1072/16
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
Four
C
conductor wire
DS1072-022A
with
with