Volume Regulation; Important - urmet domus BiBus II 1072 Manuel D'utilisation

Electrical lock time
Press the programming button (5) and wait for the
respective LED to come on.
Beeps will be repeatedly generated if there are
other stations with the same ID. Press the button
again to quit the operation, correct the mistake with
the dip-switches and repeat the operation.
Hold the "hall" button pressed for the time to be
programmed (up to 30 s). The door unit will acquire the
value and a confi rmation beep will be heard. Press the
programming button to return to normal operation.
Door phone programming
The door unit is programmed by default at the factory.
Consequently, the code-button association phase can
be skipped in systems without secondary units. In this
case, go to the door phone programming procedure
directly. The procedure consists of two steps:
A. Door phone booking (to be made on a calling
station).
B. Door phone programming.
A: Door phone booking (to be made on a calling
station)
Press the programming button and wait for the
respective LED to come on. Press the user
buttons to be associated with the door phones
once. The booking sequence according to which
the buttons are pressed must be the same as
the order in which the operator will go to the
apartments.
DO NOT press the switchboard call button.
B: Door phone programming
1. Wait for 30s until the LED starts blinking.
2. Go to the fi rst booked user, hold the button
pressed and lift the door phone handset. Two
confi rmation beeps will be heard and the LED will
fl ash to indicate that it has been programmed.
3. Go to the other booked users and repeat the
operations.
Refer to the attached sheet to remember the code/
button association sequence.
SEQUENZA DI ASSOCIAZIONE
ASSOCIATION SEQUENCE
N° DELLA POSTAZIONE (ID):
CALL MODULE NUMBER (ID):
SEQ. NOMINATIVO PULSANTE / CODICE
USER NAME PUSHBUTTON / CODE
1
2
3
4
5
IMPORTANT: The LED will start blinking if the
buttons are not booked and no operation is
carried out for 30 seconds during the programming
procedure. In this case, press the programming
button to quit programming. If required, press it
again to resume programming.
DS1072-022A
Associating 2/3 door phones in parallel in
2nd edition systems using the simplifi ed
programming procedure
To install two or three door phones in one apartment
and make them both ring when a call is received,
press the button related to the user twice or three
times with the door phones in parallel when booking
the door phones.
When you reach the apartment where the parallel
door phones are installed according to the
programming sequence, repeat the programming
sequence on both door phones.
DEFAULT PROGRAMMING
The device default settings are:
• System type: 2nd edition
• Station type: main
• Code format: numeric (0001–9999)
• Station number: 1
• Off-hook waiting time: 40s
• Busy time: 20s
• Door opener time: 3s
To restore default settings, insert the programming
device and hold bs button pressed for longer
than three seconds until you hear a beep.
Alternatively, without the programming device, hold
the programming button pressed for longer than
three seconds until you hear a beep.

VOLUME REGULATION

Volume levels are calibrated by default so not to
require adjustments in most cases.
Use a screwdriver to adjust the trimmers if required.
CALLS
Up to 82 users can be called by pressing the
corresponding buttons on the panels associated
PIANO VARIE
to the door unit with digitiser 1072/5. Additionally,
FLOOR VARIOUS
a concierge switchboard 1072/41 can be called,
simply by pressing a call button associated to
code 0000 during programming (day mode only). A
courtesy ring, similar to that generated on a called
door phone, will be heard.
15