HBM K-OP Instructions D'emploi page 32

32
Installing optical strain gages

Fig. 4.3.7: Removing the cellophane once the adhesive has cured
We recommend that you pull off the adhesive strips as soon as the

cellophane has been removed. Pull tight at an angle of 45 degrees. This will
peel off the X60.
Fig. 4.3.8: Removing the mask
The last step now is to remove the fixing. To do this, first peel off the adhesive
tape as far as the edge of the adhesive. Then pull off the remaining adhesive
tape at an acute angle.
HBM A2397-3.2 en/de/fr