HBM K-OP Instructions D'emploi page 17

17
Installing optical strain gages

Fig. 3.3.5: Rolling out the adhesive with your finger. Use the enclosed cellophane
as a separating layer.
The adhesive escaping in the longitudinal direction fixes and secures the fiber.

You can remove the cellophane as soon as the residual adhesive in the
mixing container has cured (after approx. max. 5 min).

Fig. 3.3.6: Removing the cellophane once the adhesive has cured
We recommend that you pull off the adhesive strips as soon as the

cellophane has been removed. Pull tight at an angle of 45 degrees. This will
peel off the X60.
A2397-3.2 en/de/fr HBM