HBM K-OP Instructions D'emploi page 26

26
Installing optical strain gages
The superglue is now dripped onto the measurement object. Make sure that
the Z70 falls onto the measurement object, to avoid inadvertent curing from
pressure on the adhesive.
Fig. 4.2.3: Allow about two drops of Z70 to fall onto the measurement object

Once the adhesive has spread, place a piece of Teflon -film over the
installation point (Fig. 4.2.4).

Fig. 4.2.4: Teflon -film over the installation point
Now press down on the strain gage on the measurement object with the ball
of your thumb. Maintain a constant pressure for about 1 minute (Fig. 4.2.5).
HBM A2397-3.2 en/de/fr