When Not In Use - GE Profile WPGT9150 Manuel D'utilisation Et D'installation

WHEN USING THE WASHER
I
Never reach into washer while it is moving.
Wait until the machine has completely stopped
before opening the lid.
Use this
I
Do not mix chlorine bleach with ammonia or
appliance
acids such as vinegar and/or rust remover. Mixing
only for its
different chemicals can produce a toxic gas which
intended
may cause death.
purpose as
I
Do not wash or dry articles that have been
described in
cleaned in, washed in, soaked in or spotted
this Owner's
with combustible or explosive substances (such as
Manual.
wax, oil, paint, gasoline, degreasers, dry-cleaning
solvents, kerosene) which may ignite or explode.
Do not add these substances to the wash water.
Do not use or place these substances around
your washer or dryer during operation.
I
The laundry process can reduce the flame
retardancy of fabrics. To avoid such a result,
carefully follow the garment manufacturer's
wash and care instructions.

WHEN NOT IN USE

I
Turn off water faucets to relieve pressure on
hoses and valves and to minimize leakage if
a break or rupture should occur. Check the
condition of the fill hoses; they should be
replaced every 5 years.
I
Before discarding a washer, or removing it
from service, remove the washer lid to prevent
children from hiding inside.
READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.
SAVE THESE INSTRUCTIONS
I
To minimize the possibility of electric shock,
unplug this appliance from the power supply
or disconnect the washer at the building's
distribution panel by removing the fuse or
switching off the circuit breaker before
attempting any maintenance or cleaning.
NOTE: Pressing the START/PAUSE or POWER
button does NOT disconnect the appliance
from the power supply.
I
Never attempt to operate this appliance if it is
damaged, malfunctioning, partially disassembled,
or has missing or broken parts, including a
damaged cord or plug.
I
Do not attempt to repair or replace any part of
this appliance unless specifically recommended
in this Owner's Manual, or in published user-repair
instructions that you understand and have the
skills to carry out.
I
Do not tamper with controls.
ge.com
3