Features; Extra Rinse; Delay Start - GE Profile WPGT9150 Manuel D'utilisation Et D'installation

About the washer features.
NOTE: Features may not be available on all washer models.
6
Cycle Signal
Use the SIGNAL button to change the
volume of the end of cycle signal.
Soak
Soak is an extra wash before the main
wash. Use it for heavily soiled clothes or
for clothes with a care label that
recommends soaking before washing.
Be sure to add high-efficiency detergent,
or the proper wash additive to the soak
dispenser.

Extra Rinse

Use an extra rinse when additional rinsing
is desired to remove excess dirt and
detergent from soiled loads.

Delay Start

You can delay the start of a wash cycle
for up to 24 hours. Press the DELAY START
button to choose the number of hours
you want to delay the start of the cycle,
then press the START button. The machine
will count down and start automatically at
the correct time.
MY CYCLE
To save a favorite cycle, set the desired
settings for wash cycle, soil level, spin
speed and wash temp settings and hold
down the MY CYCLE button for 3 seconds.
A beep will sound to indicate the cycle has
been saved.
To use your custom cycle, press the
MY CYCLE button before washing a load.
To change the saved cycle, set the desired
settings and hold down the MY CYCLE
button for 3 seconds.
Press the button until you reach the
desired volume.
NOTES:
• When selecting soak, it is
recommended to use powder
detergent in the main wash (detergent)
compartment.
• The maximum soak time is 3 hours.
NOTE: If you open the lid when the delay
is counting down, the machine will enter
the pause state. You must close the lid and
press START again in order to restart the
countdown.
NOTE: When using MY CYCLE, wash
options cannot be modified after the cycle
has been started.
NOTE: If you change wash options with
MY CYCLE before starting the cycle, the
MY CYCLE light will turn off and you will
be returned to the base cycle.